Step 1

Install the remote lever under bar on the rider's left side. Tighten the clamp screw clockwise to 15in-lb (1.7Nm)

Step 2

Install short pieces of housing with one ferrule, fully seat them in the remote lever.

Step 3

Install the in-line barrel adjusters in their fully threaded together configuration for maximum range.

Step 4

Install housing with a ferrule on both ends for the fork and shock.

Step 5

On remote lever, set barrel adjuster 1 turn counterclockwise from full clockwise stop. Then thread cable around pulley and under set screw.

Step 6

Put remote lever in “closed” position.

Step 7

Insert 5mm hex wrench into pulley top and rotate pulley to locked position. Holding the pulley in place, pull excess cable slack out. Still holding the pulley at lockout position, torque set screw to clamp cable with a 2mm hex wrench to 10 in-lbs. This ensures that lockout is in the correct position regardless of remote lever design. Cut off excess cable and crimp the end.

Step 8

With all housing fully seated and no slack in the system, thread the second cable though the shock remote housing and around the pulley.

Step 9

While holding the cable tight, tighten the pinch bolt with a 2mm hex wrench. Do not turn the torx screw that attaches the remote pulley to the shock.

Step 10

Cut off excess cable and crimp the end.

Step 11

Actuate lever from full lock to full open several times to verify pulley is releasing properly.

A).If pulley is sticking in lockout position the cable tension may be too high. Turn barrel adjuster counterclockwise to remove cable tension and check again.

B).If pulley/lever isn’t returning to full open, repeat remote pulley installation procedure.